Disc Holder Pattern:



Disc Holder Pattern



Instructions:

Cut 2 pieces of PC 26X21 threads for the front & back.Cut out the notch as indicated on the pattern for the front piece only and stitch as required. Overcast the notch in black. Stitch the back in Continental black stitches.Cut 2 pieces of PC 11X12 threads for the sides and stitch in Continental black stitches. Cut 1 piece of PC 26X11 threads for the bottom and leave unstitched. After all stitching is done, whipstitch together in black.

Colors are as seen on pattern

Questions or comments? Contact teresa@tsplace.com
Copyright 1997-2017 Teresa Crawford. Not for commercial use without permission

Back to T's Place!